The Pinlock® Variant Precision Optics Shield works in conjunction with the Pinlock® Variant Precision Optics Insert Lens (Sold Separately) available in Clear, Dark Smoke, and ProtecTint™. See your helmet manual for shield installation instructions.

Remove the helmet shield from the helmet. Flex the helmet shield and place the Pinlock® lens between the two pins provided in the helmet shield. Once installed, remove protective film.

Inspect the silicon seal on the Pinlock® lens. It must make full contact with the helmet shield in order to avoid any condensation forming between the helmet shield and the Pinlock® lens. If correct, re-install your helmet shield.

If the silicon seal does not make full contact with the helmet shield you can adjust the pressure by turning the outside screw counter clockwise using the outside arrow in the pin for reference. Once finished, re-install your shield.